-
n the first part of this book, we give an introduction to the basic applications of wireless com-
munications, as well as the technical problems inherent in this communication paradigm. After a
brief history of wireless, Chapter 1 describes the different types of wireless services, and works
out their fundamental differences. The subsequent Section 1.3 looks at the same problem from
a different angle: what data rates, ranges, etc., occur in practical systems, and especially, what
combination of performance measures are demanded (e.g., what data rates need to be transmitted
over short distances; what data rates are required over long distances?) Chapter 2 then describes
the technical challenges of communicating without wires, putting special emphasis on fading and
co-channel interference. Chapter 3 describes the most elementary problem of designing a wireless
system, namely to set up a link budget in either a noise-limited or an interference-limited system.
After studying this part of the book, the reader should have an overview of different types of
wireless services, and understand the technical challenges involved in each of them. The solutions
to those challenges are described in the later parts of this book.
標簽：
Communications
Wireless
Edition
2nd
上傳時間：
2020-06-01
上傳用戶：shancjb
-
Wireless communications, together with its applications and underlying technologies, is
among today’s most active areas of technology development. The very rapid pace of im-
provements in both custom and programmable integrated circuits for signal processing ap-
plications has led to the justfiable view of advanced signal processing as a key enabler of the
aggressively escalating capacity demands of emerging wireless systems. Consequently, there
has been a tremendous and very widespread effort on the part of the research community
to develop novel signal processing techniques that can fulfill this promise.
標簽：
Communication
Wireless
Systems
上傳時間：
2020-06-01
上傳用戶：shancjb
-
Nowadays sensors are part of everyday life in a wide variety of fields: scientific
applications, medical instrumentation, industrial field, ...and, last but not least,
popular mass production and low-cost goods, like smartphones and other mobile
devices. Markets and business behind the field of sensors are quite impressive.
A common trend for consumer applications is miniaturization which requires, on
one side, a lot of research, development efforts, and resources but, on the other
hand, allows costs and final application size reduction. In this scenario scientific
community and industries are very active to drive innovation.
標簽：
Magnetometers
Lorentz
Force
MEMS
上傳時間：
2020-06-06
上傳用戶：shancjb
-
This book deals with a very important problem in power system planning
for countries in which hydrogeneration accounts for the greatest part of the
system power production. During the past thirty years many techniques
have been developed to cope with the long-term operation of hydro reser-
voirs. These techniques have been discussed in a number of publications,
but they have not until now been documented in book form.
標簽：
Long-Term
Operation
Optimal
上傳時間：
2020-06-07
上傳用戶：shancjb
-
The field of cyber security, or information security, or information
assurance, depending on your preference, is an interdisciplinary one.
It is part computer science, part statistics, part psychology, part law,
and a part of many other fields. Moreover, any cyber security practi-
tioner needs to know what he or she is protecting and where to pri-
oritize. Just as someone should not spend $100 to protect something
worth $10, one cannot be blind to the other disciplines.
標簽：
Security
Smart
Grid
上傳時間：
2020-06-07
上傳用戶：shancjb
-
Radio frequency identification (RFID) is gaining in popularity, especially
as we find ourselves in this communications age and headed towards a
ubiquitous computing world. Automatic identification systems become
an important aspect not just in today’s technology but also as part of our
daily life. We need RFID in our cars, transportation systems, access
points, and even simple transactions; we also acknowledge the need for
RFID in our logistics systems, healthcare, and tracking and locating
applications.
標簽：
RFID-Enabled
Appications
Design
Sensor
and
上傳時間：
2020-06-08
上傳用戶：shancjb
-
Machine learning is a broad and fascinating field. Even
today, machine learning technology runs a substantial part of your
life, often without you knowing it. Any plausible approach to artifi-
cial intelligence must involve learning, at some level, if for no other
reason than it’s hard to call a system intelligent if it cannot learn.
Machine learning is also fascinating in its own right for the philo-
sophical questions it raises about what it means to learn and succeed
at tasks.
標簽：
Learning
Machine
Course
in
上傳時間：
2020-06-10
上傳用戶：shancjb
-
THIS PUBLICATION IS COPYRIGHT PROTECTEDCopyright ? 2014 IEC, Geneva, SwitzerlandAll rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any formor by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing fromeither IEC or IEC's member National Committee in the country of the requester. If you have any questions about IECcopyright or have an enquiry about obtaining additional rights to this publication, please contact the address below oryour local IEC member National Committee for further information.Droits de reproduction réservés. Sauf indication contraire, aucune partie de cette publication ne peut être reproduiteni utilisée sous quelque forme que ce soit et par aucun procédé, électronique ou mécanique, y compris la photocopieet les microfilms, sans l'accord écrit de l'IEC ou du Comité national de l'IEC du pays du demandeur. Si vous avez desquestions sur le copyright de l'IEC ou si vous désirez obtenir des droits supplémentaires sur cette publication, utilisezles coordonnées ci-après ou contactez le Comité national de l'IEC de votre pays de résidence.
標簽：
iec標準
上傳時間：
2021-10-21
上傳用戶：kent
-
It all started rather innocuously. I walked into Dr GT Murthy’s office one fine day, andchanged my life. “Doc” was then the General Manager, Central R&D, of a very largeelectrical company headquartered in Bombay. In his new state-of-the-art electronics center,he had hand-picked some of India’s best engineers (over a hundred already) ever assembledunder one roof. Luckily, he too was originally a Physicist, and that certainly helped me gainsome empathy. Nowadays he is in retirement, but I will always remember him as athoroughly fair, honest and facts-oriented person, who led by example. There were severalthings I absorbed from him that are very much part of my basic engineering persona today.You can certainly look upon this book as an extension of what Doc started many years agoin India … because that’s what it really is! I certainly wouldn’t be here today if I hadn’t metDoc. And in fact, several of the brash, high-flying managers I’ve met in recent years,desperately need some sort of crash course in technology and human values from Doc!
標簽：
開關電源
上傳時間：
2021-11-23
上傳用戶：
-
電子書-RTL Design Style Guide for Verilog HDL540頁A FF having a fixed input value is generated from the description in the upper portion of
Example 2-21. In this case, ’0’ is output when the reset signal is asynchronously input,
and ’1’ is output when the START signal rises. Therefore, the FF data input is fixed at
the power supply, since the typical value ’1’ is output following the rise of the START
signal.
When FF input values are fixed, the fixed inputs become untestable and the fault detection rate drops. When implementing a scan design and converting to a scan FF, the scan
may not be executed properl not be executed properly, so such descriptions , so such descriptions are not are not recommended. recommended.[1] As in the lower
part of Example 2-21, be sure to construct a synchronous type of circuit and ensure that
the clock signal is input to the clock pin of the FF.
Other than the sample shown in Example 2-21, there are situations where for certain
control signals, those that had been switched due to the conditions of an external input
will no longer need to be switched, leaving only a FF. If logic exists in a lower level and a
fixed value is input from an upper level, the input value of the FF may also end up being
fixed as the result of optimization with logic synthesis tools. In a situation like this, while
perhaps difficult to completely eliminate, the problem should be avoided as much as possible.
標簽：
RTL
verilog hdl
上傳時間：
2022-03-21
上傳用戶：canderile
