本系統基于STM32單片機設計的非接觸式電流檢測控制系統,通過OPA548片將所給任意信號放大,由100Ω電阻和INA128芯片進行電流電壓轉換放大后,利用STM32單片機對獲取的電壓信號以0.488μs頻率采樣,利用STM32單片機的FFT庫,獲得信號的諧波信息。測量電流信號精準,該設計可廣泛應用在以STM32單片機為核心控制器件的新型儀表中,性能精準且抗干擾能力強。This system is a non-contact current detection and control system based on STM32 single chip microcomputer. It amplifiesany signal through OPA548 chip, converts and amplifies the current and voltage by 100 Ω resistance and INA128 chip. The obtainedvoltage signal is sampled at the frequency of 0.488 μs by STM 32 single chip microcomputer, and the harmonic information of the signalis obtained by the FFT library of STM 32 single chip microcomputer. The measurement of current signal is accurate. This design can bewidely used in a new instrument with STM 32 single chip microcomputer as its core control device, with accurate performance and stronganti-interference capability.
標簽：
stm32
單片機
上傳時間：
2022-03-27
上傳用戶：
為了提高超高頻RFID系統中閱讀器在低信噪比的情況下仍具有較高的識別能力,提出一種基于FPGA系統結合軟件無線電方法實現超高頻RFID射頻前端電路方案。超高頻射頻識別系統必須符合EPC Class 1generation 2標準,所設計的電路系統以Xilinx公司的XC6SLX16-2CSG324FPGA芯片為硬件基礎,將數字基帶調制解調和中頻濾波電路在FPGA系統中設計實現,重點闡述了射頻前端電路的設計結構、AD/DA轉換電路,以及數字濾波器的設計。實驗結果表明,所設計的超高頻RFID閱讀器簡化了前端電路系統結構,提升了穩定性,增強了抗干擾能力。該電路系統在信噪比較低的情況下,能夠較好地實現915MHz頻率的射頻接收和發送。In order to improve the reader UHF RFID system still has a higher ability to identify,in the case of low signal-to-noise ratio.The UHF RFID systems must comply with EPC Class 1 generation 2 standard.In this paper,the design of the circuit system based on Xilinx＇s XC6SLX16-2CSG324 FPGA chip,and presents UHF RFID RF front-end circuit with software radio based on FPGA system.Digital baseband modem and IF filter circuit is designed and implemented in the FPGA system,and focused on designing the structure of the RF front-end circuit,AD/DA conversion circuits,and digital filter.Experimental results show that the UHF RFID reader de...
標簽：
915mhz
超高頻
rfid
閱讀
射頻
前端
電路
設計
上傳時間：
2022-04-17
上傳用戶：shjgzh
