說明： 51單片機控制fm1702射頻讀卡芯片讀寫mifare1卡全套資料。包括電路圖，pcb板圖，上、下位機軟件及源碼，stc單片機下載軟件，各種資料文檔等。(51 SCM control fm1702 RF reader CHip card reader mifare1 a full set of data. Including the circuit diagram, pcb board map, the upper and lower-bit machine software and source code, stc SCM download software, all kinds of information documentation.)
上傳時間： 2022-05-27
上傳用戶：
說明： 基于單片機的rc522模塊的門禁系統源碼以及原理圖(The source code and schematic diagram of the entrance guard system of rc522 module based on single CHip microcomputer)
標簽： 門禁系統
上傳時間： 2022-06-06
上傳用戶：ttalli
說明： 合泰單片機HT66F50例程工程源程序，合泰各種例程demo都在里面(HT66F50 routine engineering source program of Hetai single CHip microcomputer)
標簽： 單片機
上傳時間： 2022-06-06
上傳用戶：默默
說明： 基于51單片機驅動ADS1115進行AD采集在1602上顯示程序源碼(Based on 51 single-CHip drive diode for water lamp processing, including driving, testing, C file)
上傳時間： 2022-06-07
上傳用戶：
RTL9047A 為車用乙太網single CHip 交換機方案,如下圖port0~port3 總共提供4ports 100BASE-T1,不用外掛PHY可節省cost 及PCB空間;port4為 selection port可選擇設定100BASE-T1或SGMII,其SGMII個外接CPU或?qū)酉嗤吞杝witch做cascade擴充;port5為 selection port可選擇設定傳統100base-TX FE PHY, SGMII或 RGMII/MII/RMII,其100base-TX 界面作為車載Diagnostic界面;port6為RGMII/MII/RMII 界面,可用來外接CPU或擴充網路界面等應用。
上傳時間： 2022-06-07
上傳用戶：
ICN6201/02 is a bridge CHip which receives MIPI? DSI inputs and sends LVDS outputs. MIPI? DSI supports up to 4 lanes and each lane operates at 1Gbps maximum; the totally maximum input bandwidth is 4Gbps; and the MIPI defined ULPS(ultra-low-power state) is also supported. ICN6201 decodes MIPI? DSI 18bepp RGB666 and 24bpp RGB888 packets.The LVDS output 18 or 24 bits pixel with 25MHz to 154MHz, by VESA or JEIDA format.ICN6201/02 support video resolution up to FHD (1920x1080) and WUXGA (1920x1200).ICN6201 adopts QFN48 package and ICN6202 adopts QFN40 package
標簽： icn6202
上傳時間： 2022-06-10
上傳用戶：kingwide
DescriptionThe IMX385LQR-C is a diagonal 8.35 mm (Type 1/2) CMOS active pixel type solid-state image sensor with a squarepixel array and 2.13 M effective pixels. This CHip operates with analog 3.3 V, digital 1.2 V, and interface 1.8 V triplepower supply, and has low power consumption. High sensitivity, low dark current and no smear are achieved throughthe adoption of R, G and B primary color mosaic filters. This CHip features an electronic shutter with variablecharge-integration time.(Applications: Surveillance cameras)
標簽： CMOS傳感器 IMX385LQR-C
上傳時間： 2022-06-18
上傳用戶：
sony CMOS傳感器datasheet，IMX178LQJ-C_Data_SheetDescriptionThe IMX178LQJ-C is a diagonal 8.92 mm (Type 1/1.8) CMOS active pixel type image sensor with a square pixelarray and 6.44 M effective pixels. This CHip operates with analog 2.9 V, digital 1.2 V and interface 1.8 V triple powersupply, and has low power consumption.High sensitivity, low dark current and no smear are achieved through the adoption of R, G and B primary colormosaic filters.This CHip features an electronic shutter with variable charge-integration time.(Applications: Surveillance cameras, FA cameras, Industrial cameras)
標簽： CMOS傳感器 IMX178LQJ-C
上傳時間： 2022-06-18
上傳用戶：
INTRODUCTION In the past, adding speech recording and playback capability to a product meant using a digital signal processor or a specialized audio CHip. Now, using a simplified Adaptive Differential Pulse Code Modulation(ADPCM) algorithm, these audio capabilities can be added to any PICmicro device. This application note will cover the ADPCM compression and decompression algorithms, performance comparison of all PICmicro devices, and an application using a PIC16C72 micro-controller.DEFINITION OF TERMS step size -value of the step used for quantization of ana-log signals and inverse quantization of a number of steps.quantization -the digital form of an analog input signal is represented by a finite number of steps.adaptive quantization -the step size of a quantizer is dramatically changed with time in order to adapt to a changing input signal.inverse quantizer -a finite number of steps is converted into a digital representation of an analog signal.
上傳時間： 2022-06-20
上傳用戶：
1:打開J-Flash ARM后,首先點擊File-OpenProject...,從中選擇STM32F103RB.jflash。(例子芯片,直接在提示的目錄下找) 2.點擊File-Open data file...選擇要燒錄的可執行文件(.hex 或者 .bin) 3:options-project settings 在里面配置cpu型號,下載方式 4: 選擇燒錄文件后,點擊Target-connect,鏈接一下硬件是否通。如果能夠連接成功會了LOG窗口最后一行顯示“Connected successfully”。5:按F3擦除芯片。6.按F5鍵將程序?qū)懭胄酒?.硬件鏈接上之后，點擊Target-Secure CHip防止程序被惡意讀出。如果您的芯片用于調試，不要執行本步驟。
標簽： J-Flash
上傳時間： 2022-06-22
上傳用戶：kingwide
蟲蟲下載站版權所有 京ICP備2021023401號-1
