The solution presented in this paper and in the attached source files emulates the mostimportant SSC functions by using SW routines implemented in C. The code is focused onthe SAB C513, but will fit to all C500 derivatives.Beyond the low level software drivers a test shell is delivered. This shell allows a quicktest of the software drivers by an emulator or a starter kit demo board.
上傳時間： 2013-11-24
上傳用戶：363186
基于P87 C591的CAN總線系統智能節點設計Design of CAN System Intelligent Node Based on P87C591 給出了基于帶CAN控制器的單片8位微控制器P87C591的智能節點的硬件電路及軟件結構，詳細介紹了設計中的難點及實現過程中應注意的問題。關鍵詞:CAN總線;智能節點 Abstract:A h ardc ircuita nds oftw arec onfigurationo fth ei ntelligentnode based on a microcontroller with CAN controller P87C591 arepresented.E speciallyt hec ruxi nd esigninga ndt hep roblemst hatshould be paid attention in realizing are discussed in details.Keyw ords:C AN;in telligentn ode CA N 總線 是德國Bosch從20世紀80年代初為解決現代汽車中眾多的控制與測試儀器之間的數據交換而開發的一種串行數據通信協議，它是一種多主總線，通信介質可以是雙絞線、同軸電纜或光導纖維。由于CAN總線具有較強的糾錯能力，支持差分收發，因而適合高噪聲環境。并具有較遠的傳輸距離，適用于許多領域的分布式測控系統。目前已在工業自動化、建筑物環境控制、醫療設備等許多領域得到廣泛的應用。CAN已成為國際標準化組織IS011898標準。
上傳時間： 2013-10-30
上傳用戶：xymbian
針對使用硬件描述語言進行設計存在的問題，提出一種基于FPGA并采用DSP Builder作為設計工具的數字信號處理器設計方法。并按照Matlab/Simulink/DSP Builder/QuartusⅡ設計流程，設計了一個12階FIR 低通數字濾波器，通過Quartus 時序仿真及嵌入式邏輯分析儀SignalTapⅡ硬件測試對設計進行了驗證。結果表明，所設計的FIR 濾波器功能正確，性能良好。 Abstract: Aiming at the problems in designing DSP using HDL，a method of designing DSP based on FPGA which using DSP Builder as designed tool is pointed out.A 12-order low-pass FIR digital filter was designed according to the process of Matlab/Simulink/DSP Builder/QuartusⅡ, and the design was verified by the timing simulation based on QuartusⅡand practical test based on SignalTapⅡ. The result shows the designed filter is correct in function and good in performance.
上傳時間： 2013-11-17
上傳用戶：lo25643
Accurate measurement of the third order intercept pointfor low distortion IC products such as the LT5514 requirescertain precautions to be observed in the test setup andtesting procedure. The LT5514 linearity performance ishigh enough to push the test equipment and test set-up totheir limits. A method for accurate measurement of thirdorder intermodulation products, IM3, with standard testequipment is outlined below.It is also important to correctly interpret the LT5514specification with respect to ROUT, and the impact ofdemo-board transmission-line termination loss whenevaluating the linearity performance, as explained in theLT5514 Datasheet and in Note 1 of this document.
上傳時間： 2013-11-14
上傳用戶：l254587896
關于NETFLOW信息分析的軟件。 is a netflow analyzer. It uses MySQL database to store accounting information. Filters, used in the JFlowAnalyzer, allows very flexible classificate any kind of traffic and store it in the differend fields in database
標簽： information accounting analyzer database
上傳時間： 2014-01-27
上傳用戶：kr770906
This book is about the management of business processes. This is certainly not a new topic. Since the beginning of the Industrial Revolution, it has been written about from every possible point of view—economic, sociological, psychological, accountancy, mechanical engineering and business administration. In this book, we examine the management of business processes from the perspective of computing, or—to put it more broadly—of information technology. The reason is that information technology has made huge leaps forward in recent years, resulting in the creation of completely new ways of organizing business processes. The development of generic software packages for managing business processes—so-called workflow management systems (WFMS)—is particularly important in this respect.
標簽： This management certainly processes
上傳時間： 2013-11-29
上傳用戶：shus521
zemax源碼： This DLL models a standard ZEMAX surface type, either plane, sphere, or conic The surface also demonstrates a user-defined apodization filter The filter is defined as part of the real ray trace, case 5 The filter can be used at the stop to produce x-y Gaussian apodization similar to the Gaussian pupil apodization in ZEMAX but separate in x and y. The amplitude apodization is of the form EXP[-(Gx(x/R)^2 + Gy(y/R)^2)] The transmission is of the form EXP[-2(Gx(x/R)^2 + Gy(y/R)^2)] where x^2 + y^2 = r^2 R = semi-diameter The tranmitted intensity is maximum in the center. T is set to 0 if semi-diameter < 1e-10 to avoid division by zero.
標簽： standard surface models either
上傳時間： 2013-12-05
上傳用戶：003030
％CHECKBOUNDS Move the initial point within the (valid) bounds. ％ [X,LB,UB,X,FLAG] = CHECKBOUNDS(X0,LB,UB,nvars) ％ checks that the upper and lower ％ bounds are valid (LB <= UB) and the same length as X (pad with -inf/inf ％ if necessary) warn if too long. Also make LB and UB vectors if not ％ already. ％ Finally, inf in LB or -inf in UB throws an error.
標簽： CHECKBOUNDS the initial bounds
上傳時間： 2015-10-26
上傳用戶：caiiicc
The ability to write efficient, high-speed arithmetic routines ultimately depends upon your knowledge of the elements of arithmetic as they exist on a computer. That conclusion and this book are the result of a long and frustrating search for information on writing arithmetic routines for real-time embedded systems. With instruction cycle times coming down and clock rates going up, it would seem that speed is not a problem in writing fast routines. In addition, math coprocessors are becoming more popular and less expensive than ever before and are readily available. These factors make arithmetic easier and faster to use and implement. However, for many of you the systems that you are working on do not include the latest chips or the faster processors. Some of the most widely used microcontrollers used today are not Digital Signal Processors (DSP), but simple eight-bit controllers such as the Intel 8051 or 8048 microprocessors.
標簽： arithmetic high-speed ultimately efficient
上傳時間： 2014-11-30
上傳用戶：lizhen9880
Abstract The Lucene Server project is an attempt to extend the Jakarta Lucene tool with server capabilities. Lucene is a robust Java API that enables you creating indexes from text sources and perform powerful searches on these indexes. With Lucene, creating an index must be done programmatically and there are almost no possibilities of integrating index management in a distributed environment. In other words, out of the box, Lucene is suitable for integrating indexing and searching possibilities in a single application but not for providing index/search services for multiple applications. The Lucene Server project comes with a Java API that propose the following make it easy to create indexes in a declarative way by simply providing an XML configuration document. make it easy to personalize the way Lucene must handle different kind of data sources. provide services for index management and searching that can be accessed from several applications. enable batch tasks scheduling.
標簽： Lucene Abstract Jakarta project
上傳時間： 2016-01-10
上傳用戶：songrui
