亚洲欧美第一页_禁久久精品乱码_粉嫩av一区二区三区免费野_久草精品视频

蟲蟲首頁| 資源下載| 資源專輯| 精品軟件
登錄| 注冊

PCI-Labcard

  • 基于PCI總線的ARINC429接口卡設計

    利用PCI專用接口芯片PCI9052和DEI1016 429總線收發芯片設計了ARINC429接口卡,采用DSP作為主控CPU完成數據自動處理,用雙口RAM完成DSP與PCI總線數據交換。實驗表明:所設計的接口卡傳輸效率高,可靠性好,開發簡單。

    標簽: ARINC PCI 429 總線

    上傳時間: 2014-12-30

    上傳用戶:love1314

  • PCI橋接IP Core的VeriIog HDL實現

    PCI總線是目前最為流行的一種局部性總線 通過對PCI總線一些典型功能的分析以及時序的闡述,利用VetilogHDL設計了一個將非PCI功能設備轉接到PC1總線上的IP Core 同時,通過在ModeISim SE PLUS 6.0 上運行測試程序模塊,得到了理想的仿真數據波形,從軟件上證明了功能的實現。

    標簽: VeriIog Core PCI HDL

    上傳時間: 2014-12-30

    上傳用戶:himbly

  • PCI總線的應用

    The PCI Special Interest Group disclaims all warranties and liability for the use of this document and the information contained herein and assumes no responsibility for any errors that may appear in this document, nor does the PCI Special Interest Group make a commitment to update the information contained herein.

    標簽: PCI 總線

    上傳時間: 2013-11-01

    上傳用戶:KSLYZ

  • PCI總線規范及其接口

    作為一種獨立于處理器的局部總線,PCI非常適用于網絡適配器、硬盤驅動器、全動態視頻卡、圖形卡及各類高速外設。據稱,目前有90%的Pentium處理器采用PCI做為系統總線。

    標簽: PCI 總線規范 接口

    上傳時間: 2013-11-07

    上傳用戶:liaocs77

  • 基于Virtex5的PCI接口電路

    PCI Express是由Intel,Dell,Compaq,IBM,Microsoft等PCI SIG聯合成立的Arapahoe Work Group共同草擬并推舉成取代PCI總線標準的下一代標準。PCI Express利用串行的連接特點能輕松將數據傳輸速度提到一個很高的頻率,達到遠遠超出PCI總線的傳輸速率。一個PCI Express連接可以被配置成x1,x2,x4,x8,x12,x16和x32的數據帶寬。x1的通道能實現單向312.5 MB/s(2.5 Gb/s)的傳輸速率。Xilinx公司的Virtex5系列FPGA芯片內嵌PCI-ExpressEndpoint Block硬核,為實現單片可配置PCI-Express總線解決方案提供了可能?! ”疚脑谘芯縋CI-Express接口協議和PCI-Express Endpoint Block硬核的基礎上,使用Virtex5LXT50 FPGA芯片設計PCI Express接口硬件電路,實現PCI-Express數據傳輸

    標簽: Virtex5 PCI 接口電路

    上傳時間: 2013-12-27

    上傳用戶:wtrl

  • XAPP708 -133MHz PCI-X到128MB DDR小型DIMM存儲器橋

      The Virtex-4 features, such as the programmable IDELAY and built-in FIFO support, simplifythe bridging of a high-speed, PCI-X core to large amounts of DDR-SDRAM memory. Onechallenge is meeting the PCI-X target initial latency specification. PCI-X Protocol Addendum tothe PCI Local Bus Specification Revision 2.0a ([Ref 6]) dictates that when a target signals adata transfer, "the target must do so within 16 clocks of the assertion of FRAME#." PCItermination transactions, such as Split Response/Complete, are commonly used to meet thelatency specifications. This method adds complexity to the design, as well as additional systemlatency. Another solution is to increase the ratio of the memory frequency to the PCI-X busfrequency. However, this solution increases the required power and clock resource usage.

    標簽: PCI-X XAPP DIMM 708

    上傳時間: 2013-11-24

    上傳用戶:18707733937

  • PCI-PCI橋在線讀寫EEPROM的技巧

      PCI-PCI 橋啟動時,一般需要從EEPROM 預讀取配置數據。更改EEPROM中的數據一般需要專用的燒結器,這給調試過程帶來不便。尤其是采用表貼封裝的EEPROM。本文以Intel 公司的Dec21554PCI-PCI 橋為例,介紹一種在線讀寫EEPROM 的方法。EEPROM選用的是ATMEL 公司生產的AT93LC66,4Kbit,按512×8bit 組織。

    標簽: PCI-PCI EEPROM 在線讀寫

    上傳時間: 2013-11-08

    上傳用戶:trepb001

  • pci e PCB設計規范

    This document provides practical, common guidelines for incorporating PCI Express interconnect layouts onto Printed Circuit Boards (PCB) ranging from 4-layer desktop baseboard designs to 10- layer or more server baseboard designs. Guidelines and constraints in this document are intended for use on both baseboard and add-in card PCB designs. This includes interconnects between PCI Express devices located on the same baseboard (chip-to-chip routing) and interconnects between a PCI Express device located “down” on the baseboard and a device located “up” on an add-in card attached through a connector. This document is intended to cover all major components of the physical interconnect including design guidelines for the PCB traces, vias and AC coupling capacitors, as well as add-in card edge-finger and connector considerations. The intent of the guidelines and examples is to help ensure that good high-speed signal design practices are used and that the timing/jitter and loss/attenuation budgets can also be met from end-to-end across the PCI Express interconnect. However, while general physical guidelines and suggestions are given, they may not necessarily guarantee adequate performance of the interconnect for all layouts and implementations. Therefore, designers should consider modeling and simulation of the interconnect in order to ensure compliance to all applicable specifications. The document is composed of two main sections. The first section provides an overview of general topology and interconnect guidelines. The second section concentrates on physical layout constraints where bulleted items at the beginning of a topic highlight important constraints, while the narrative that follows offers additional insight.  

    標簽: pci PCB 設計規范

    上傳時間: 2014-01-24

    上傳用戶:s363994250

  • PCI-E8622數據采集卡的功能介紹

    PCI-E是一種高速傳輸總線形式。

    標簽: PCI-E 8622 數據采集卡

    上傳時間: 2013-12-18

    上傳用戶:宋桃子

  • PCI-1734快速安裝使用手冊

    PCI-1734快速安裝使用手冊PCI-1734快速安裝使用手冊PCI-1734快速安裝使用手冊PCI-1734快速安裝使用手冊PCI-1734快速安裝使用手冊PCI-1734快速安裝使用手冊PCI-1734快速安裝使用手冊

    標簽: 1734 PCI 安裝使用

    上傳時間: 2013-10-22

    上傳用戶:ssz1990

主站蜘蛛池模板: 黑龙江省| 西乡县| 南昌县| 岢岚县| 明水县| 阿城市| 邯郸县| 东源县| 文山县| 开远市| 江西省| 博爱县| 长海县| 博客| 连州市| 依安县| 余江县| 米泉市| 阿巴嘎旗| 灵山县| 加查县| 辽阳市| 福安市| 景宁| 神池县| 游戏| 洮南市| 山东| 天全县| 若羌县| 抚松县| 沅陵县| 来凤县| 双城市| 镇巴县| 阿拉善左旗| 大港区| 新田县| 苗栗县| 刚察县| 朝阳区|