VxWorks是WindRiver（風河）公司開發的嵌入式實時操作系統（RTOS），由于它的高實時性，所以廣泛地應用于軍事、工業控制、通信等領域；分析了VxWorks下PCI總線多功能數據采集卡的實現方法；以ADLINK的PCI7396數據采集卡為例，介紹PCI總線設備的配置空間，包括它的結構及訪問方法，重點介紹PCI總線設備在VxWorks下驅動程序的開發步驟及編程要點，并對開發過程中的關鍵部分給予代碼說明；在某綜合控制系統中，開發的驅動程序運行穩定、可靠。
上傳時間： 2013-11-02
上傳用戶：masochism
利用PCI專用接口芯片PCI9052和DEI1016 429總線收發芯片設計了ARINC429接口卡，采用DSP作為主控CPU完成數據自動處理，用雙口RAM完成DSP與PCI總線數據交換。實驗表明：所設計的接口卡傳輸效率高，可靠性好，開發簡單。
上傳時間： 2014-12-30
上傳用戶：love1314
PCI總線是目前最為流行的一種局部性總線 通過對PCI總線一些典型功能的分析以及時序的闡述，利用VetilogHDL設計了一個將非PCI功能設備轉接到PC1總線上的IP Core 同時，通過在ModeISim SE PLUS 6．0 上運行測試程序模塊，得到了理想的仿真數據波形，從軟件上證明了功能的實現。
上傳時間： 2014-12-30
上傳用戶：himbly
The PCI Special Interest Group disclaims all warranties and liability for the use of this document and the information contained herein and assumes no responsibility for any errors that may appear in this document, nor does the PCI Special Interest Group make a commitment to update the information contained herein.
上傳時間： 2013-11-01
上傳用戶：KSLYZ
作為一種獨立于處理器的局部總線,PCI非常適用于網絡適配器、硬盤驅動器、全動態視頻卡、圖形卡及各類高速外設。據稱,目前有90%的Pentium處理器采用PCI做為系統總線。
上傳時間： 2013-11-07
上傳用戶：liaocs77
PCI Express是由Intel，Dell，Compaq，IBM，Microsoft等PCI SIG聯合成立的Arapahoe Work Group共同草擬并推舉成取代PCI總線標準的下一代標準。PCI Express利用串行的連接特點能輕松將數據傳輸速度提到一個很高的頻率，達到遠遠超出PCI總線的傳輸速率。一個PCI Express連接可以被配置成x1，x2，x4，x8，x12，x16和x32的數據帶寬。x1的通道能實現單向312.5 MB／s（2.5 Gb／s）的傳輸速率。Xilinx公司的Virtex5系列FPGA芯片內嵌PCI-ExpressEndpoint Block硬核，為實現單片可配置PCI-Express總線解決方案提供了可能?！ ”疚脑谘芯縋CI-Express接口協議和PCI-Express Endpoint Block硬核的基礎上，使用Virtex5LXT50 FPGA芯片設計PCI Express接口硬件電路，實現PCI-Express數據傳輸
上傳時間： 2013-12-27
上傳用戶：wtrl
The Virtex-4 features, such as the programmable IDELAY and built-in FIFO support, simplifythe bridging of a high-speed, PCI-X core to large amounts of DDR-SDRAM memory. Onechallenge is meeting the PCI-X target initial latency specification. PCI-X Protocol Addendum tothe PCI Local Bus Specification Revision 2.0a ([Ref 6]) dictates that when a target signals adata transfer, "the target must do so within 16 clocks of the assertion of FRAME#." PCItermination transactions, such as Split Response/Complete, are commonly used to meet thelatency specifications. This method adds complexity to the design, as well as additional systemlatency. Another solution is to increase the ratio of the memory frequency to the PCI-X busfrequency. However, this solution increases the required power and clock resource usage.
上傳時間： 2013-11-24
上傳用戶：18707733937
This document provides practical, common guidelines for incorporating PCI Express interconnect layouts onto Printed Circuit Boards (PCB) ranging from 4-layer desktop baseboard designs to 10- layer or more server baseboard designs. Guidelines and constraints in this document are intended for use on both baseboard and add-in card PCB designs. This includes interconnects between PCI Express devices located on the same baseboard (chip-to-chip routing) and interconnects between a PCI Express device located “down” on the baseboard and a device located “up” on an add-in card attached through a connector. This document is intended to cover all major components of the physical interconnect including design guidelines for the PCB traces, vias and AC coupling capacitors, as well as add-in card edge-finger and connector considerations. The intent of the guidelines and examples is to help ensure that good high-speed signal design practices are used and that the timing/jitter and loss/attenuation budgets can also be met from end-to-end across the PCI Express interconnect. However, while general physical guidelines and suggestions are given, they may not necessarily guarantee adequate performance of the interconnect for all layouts and implementations. Therefore, designers should consider modeling and simulation of the interconnect in order to ensure compliance to all applicable specifications. The document is composed of two main sections. The first section provides an overview of general topology and interconnect guidelines. The second section concentrates on physical layout constraints where bulleted items at the beginning of a topic highlight important constraints, while the narrative that follows offers additional insight.
上傳時間： 2014-01-24
上傳用戶：s363994250
PCI-E是一種高速傳輸總線形式。
上傳時間： 2013-12-18
上傳用戶：宋桃子
PCI-1734快速安裝使用手冊PCI-1734快速安裝使用手冊PCI-1734快速安裝使用手冊PCI-1734快速安裝使用手冊PCI-1734快速安裝使用手冊PCI-1734快速安裝使用手冊PCI-1734快速安裝使用手冊
上傳時間： 2013-10-22
上傳用戶：ssz1990
