NEC 16位MCU參考手冊 The 78K0R/IC3 is a 16-bit single-chip microcontroller that uses a 78K0R CPU core and incorporates peripheral functions, such as ROM/RAM, a multi-function timer, a multi-function serial interface, an A/D converter, a programmable gain amplifier (PGA), a comparator, a real-time counter, and a watchdog timer.
上傳時間： 2013-11-02
上傳用戶：努力努力再努力
This application report discusses the design of non-invasive optical plethysmographyalso called as pulsoximeter using the MSP430FG437 Microcontroller (MCU). Thepulsoximeter consists of a peripheral probe combined with the MCU displaying theoxygen saturation and pulse rate on a LCD glass. The same sensor is used for bothheart-rate detection and pulsoximetering in this application. The probe is placed on aperipheral point of the body such as a finger tip, ear lobe or the nose. The probeincludes two light emitting diodes (LEDs), one in the visible red spectrum (660nm) andthe other in the infrared spectrum (940nm). The percentage of oxygen in the body isworked by measuring the intensity from each frequency of light after it transmitsthrough the body and then calculating the ratio between these two intensities.
標簽： Pulsoximeter Single-Chip Des
上傳時間： 2013-10-27
上傳用戶：黑漆漆
數字時鐘應用資料 單片計算機即單片微型計算機。（Single-Chip Microcomputer ）,是 集CPU ,RAM ,ROM ,定時，計數和多種接口于一體的微控制器。他體積小，成本低，功能強，廣泛應用于智能產品和工業自動化上。而51 單片機是各單片機中最為典型和最有代表性的一種。這次畢業設計通過對它的學習，應用，從而達到學習、設計、開發軟、硬的能力。
上傳時間： 2013-10-13
上傳用戶：zhqzal1014
本文介紹了一種基于單片機的健身車轉速測量系統。該系統具有電路簡單、使用方便等特點。文中詳細介紹了該系統的工作原理,并且給出了它的硬件原理圖和軟件設計程序框圖。關鍵詞:轉速 單片機 測量ABSTRACT :This paper introduces a measuring system of the rotational velocity of exercise bike based on single - chip microcomputer . It has such advantages : simple circuit ,convenient use and so on. The work principle is presented in detail in this paper and the block diagram of hardware and program flow chart are giv2 en as well .KEYWORDS :Rotational velocity Single - chip microcomputer Measuring
上傳時間： 2013-11-02
上傳用戶：源弋弋
自動檢測80C51串行通訊中的波特率:本文介紹一種在80C51 串行通訊應用中自動檢測波特率的方法。按照經驗，程序起動后所接收到的第1 個字符用于測量波特率。這種方法可以不用設定難于記憶的開關，還可以免去在有關應用中使用多種不同波特率的煩惱。人們可以設想：一種可靠地實現自動波特檢測的方法是可能的，它無須嚴格限制可被確認的字符。問題是：在各種的條件下，如何可以在大量允許出現的字符中找出波特率定時間隔。顯然，最快捷的方法是檢測一個單獨位時間（single bit time），以確定接收波特率應該是多少。可是，在RS-232 模式下，許多ASCII 字符并不能測量出一個單獨位時間。對于大多數字符來說，只要波特率存在合理波動（這里的波特率是指標準波特率），從起始位到最后一位“可見”位的數據傳輸周期就會在一定范圍內發生變化。此外，許多系統采用8 位數據、無奇偶校驗的格式傳輸ASCII 字符。在這種格式里，普通ASCII 字節不會有MSB 設定，并且，UART總是先發送數據低位（LSB），后發送數據高位（MSB），我們總會看見數據的停止位。在下面的波特率檢測程序中，先等待串行通訊輸入管腳的起始信號（下降沿），然后起動定時器T0。在其后的串行數據的每一個上升沿，將定時器T0 的數值捕獲并保存。當定時器T0溢出時，其最后一次捕獲的數值即為從串行數據起始位到最后一個上升沿（我們假設是停止位）過程所持續的時間。
上傳時間： 2014-08-22
上傳用戶：dajin
The TRS232E is a dual driver/receiver that includes a capacitive voltage generator to supply TIA/RS-232-Fvoltage levels from a single 5-V supply. Each receiver converts TIA/RS-232-F inputs to 5-V TTL/CMOS levels.This receiver has a typical threshold of 1.3 V, a typical hysteresis of 0.5 V, and can accept ±30-V inputs. Eachdriver converts TTL/CMOS input levels into TIA/RS-232-F levels. The driver, receiver, and voltage-generatorfunctions are available as cells in the Texas Instruments LinASIC™ library.
上傳時間： 2013-10-07
上傳用戶：waitingfy
The main oscillator allows either a crystal or single-ended input clock signal. Cost-sensitiveapplications typically use an external crystal with the on-chip oscillator circuit since it is the mostcost-effective solution. It is also possible to use the internal oscillator to clock the device after theboot process has completed.
標簽： Stellaris Clocking Options for
上傳時間： 2013-10-14
上傳用戶：pol123
The MAX3243E device consists of three line drivers, five line receivers, and a dual charge-pump circuit with±15-kV ESD (HBM and IEC61000-4-2, Air-Gap Discharge) and ±8-kV ESD (IEC61000-4-2, Contact Discharge)protection on serial-port connection pins. The device meets the requirements of TIA/EIA-232-F and provides theelectrical interface between an asynchronous communication controller and the serial-port connector. Thiscombination of drivers and receivers matches that needed for the typical serial port used in an IBM PC/AT, orcompatible. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-Vsupply. In addition, the device includes an always-active noninverting output (ROUT2B), which allowsapplications using the ring indicator to transmit data while the device is powered down. The device operates atdata signaling rates up to 250 kbit/s and a maximum of 30-V/ms driver output slew rate.
標簽： MULTICHANNEL 5.5 TO RS
上傳時間： 2013-10-19
上傳用戶：ddddddd
MCU(單片機)對可控硅的控制:交流市電控制――ＭＣＵ對可控硅的控制 郭江辛 07-23-03在用可控硅對交流市電控制中，主要注意以下幾個方面：一， 同步信號 （弄不好都會產生不均勻的斬波，控制白熾燈表現為燈閃）1) 清楚同步信號在交流周期中的位置,最好在交流零點選取.在一些阻容降壓對MCU 供電電路中,最好直接在交流電源兩端取同步信號（過零點）,以避免計算阻容產生的象移(PHASE SHIFT)2) 同步信號要穩定二， 控制信號 （弄不好則可控硅不能通，或一直通）1） 可控硅斷路時，可控硅控制極（GATE）最好是開路，沒有開極的MCU可加如下電路：
上傳時間： 2014-05-05
上傳用戶：comer1123
基于單DSP的VoIP模擬電話適配器研究與實現:提出和實現了一種新穎的基于單個通用數字信號處理器(DSP)的VoIP模擬電話適配器方案。DSP的I/O和存儲資源非常有限，通常適于運算密集型應用，不適宜控制密集型應用[5]。該系統高效利用單DSP的I/O和片內外存儲器資源，采用μC/OS-II嵌入式實時操作系統，支持SIP和TCP-UDP/IP協議，通過LAN或者寬帶接入，使普通電話機成為Internet終端，實現IP電話。該系統軟硬件結構緊湊高效，運行穩定，成本低，具有廣闊的應用前景。關鍵詞：模擬電話適配器；IP電話；數字信號處理器；μC/OS-II 【Abstract】This paper presents a VoIP ATA solution based on a single digital signal processor (DSP). DSPs are suitable for arithmetic-intensiveapplication and unsuitable for control-intensive application because of the limitation of I/O and memory resources. This solution is based on a 16-bitfixed-point DSP and μC/OS-II embedded real-time operating system. It makes good use of the limited resources, supports SIP and TCP-UDP/IPprotocol. It can connect the analog telephone to Internet and realize the VoIP application. This system has a great future for its high efficiency andlow cost.【Key words】Analog telephone adapter (ATA); Voice over Internet protocol (VoIP); Digital signal processor (DSP); μC/OS-II Research and Implementation of VoIPATA Based on Single DSP
上傳時間： 2013-11-20
上傳用戶：Wwill
<input id="gy82w"></input>