The PW5300 is a current mode boost DC-DC converter. Its PWM circuitry with built-in 0.2? powerMOSFET make this regulator highly power efficient. The internal compensation network alsominimizes as much as 6 external component counts. The non-inverting input of error amplifierconnects to a 0.6V precision reference voltage and internal soft-start function can reduce the inrushcurrent. The PW5300 is available in the SOT23-6L package and provides space-saving PCB for theapplication fields
標簽： pw5300
上傳時間： 2022-02-11
上傳用戶：jiabin
《你好,放大器(初識篇)》，科學出版社出版，外文書名: Hello, amplifier，作者：楊建國。本書是《你好，放大器》的初識篇，是學習放大器的入門書。第1章介紹放大器的歷史和分類定義。第2章用大量篇幅介紹放大器關鍵指標，以及閱讀數據手冊的方法。第3章介紹各種各樣的運算放大器，包括精密運放、高速運放、電流反饋型運放和全差分運放。第4章是使用放大器的共性問題，這些問題都是作者在指導學生的過程中頻繁遇到的。第5章介紹一些典型的放大電路。最后，第6章針對初學者介紹儀器、調試、故障排查，以及報告撰寫。針對“如何讓更多用戶簡單使用放大器”這一問題，《你好,放大器(初識篇)》從學習、應用、設計等多角度，講解放大器定義、分類和選用，運算放大器的關鍵指標，多種多樣的運算放大器，使用放大器的共性問題，典型放大電路分析，儀器使用、焊接、調試和撰寫報告等內容。《你好,放大器(初識篇)》適合學過模擬電子技術但還不能完全駕馭放大器的讀者，特別是參加全國大學生電子設計競賽的學生閱讀，也適用于企業的員工培訓和再提高。
標簽： 放大器
上傳時間： 2022-02-28
上傳用戶：kent
ADC模數轉換器件Altium Designer AD原理圖庫元件庫SV text has been written to file : 4.4 - ADC模數轉換器件.csvLibrary Component Count : 29Name Description----------------------------------------------------------------------------------------------------ADC0800 National 8-Bit Analog to Digital ConverterADC0809 ADC0831 ADCADC0832 ADC8 Generic 8-Bit A/D ConverterCLC532 High-Speed 2:1 Analog MultiplexerCS5511 National 16-Bit Analog to Digital ConverterDAC8 Generic 8-Bit D/A ConverterEL1501 Differential line Driver/ReceiverEL2082 Current-Mode MultiplierEL4083 Current Mode Four Quadrant MultiplierEL4089 DC Restored Video amplifierEL4094 Video Gain Control/FaderEL4095 Video Gain Contol/Fader/MultiplexerICL7106 LMC6953_NSC PCI Local Bus Power SupervisorMAX4147 300MHz, Low-Power, High-Output-Current, Differential Line DriverMAX4158 350MHz 2-Channel Video Multiplexer-amplifierMAX4159 350MHz 2-Channel Video Multiplexer-amplifierMAX4258 250MHz, 2-Channel Video Multiplexer-amplifierMAX4259 250MHz 2-Channel Video Multiplexer-amplifierMAX951 Ultra-Low-Power, Single-Supply Op Amp + Comparator + ReferenceMAX952 Ultra-Low-Power, Single-Supply Op Amp + Comparator + ReferenceMC1496 Balanced Modulator/DemodulatorPLL100k Generic Phase Locked LoopPLL10k Generic Phase Locked LoopPLL5k Generic Phase Locked LoopPLLx Generic Phase Locked Loop水位計
標簽： adc 模數轉換 altium designer
上傳時間： 2022-03-13
上傳用戶：
本系統采用電動機電樞供電回路串接采樣電阻的方式來實現對小型直流有刷電動機的轉速測量。該系統主要由二階低通濾波電路,小信號放大電路、單片機測量顯示電路、開關穩壓電源電路等組成。同時自制電機測速裝置,用高頻磁環作為載體,用線圈繞制磁環,利用電磁感應原理檢測電機運行時的漏磁,將變化的磁場信號轉化為磁環上的感應電流。用信號處理單元電路將微弱電信號轉化為脈沖信號,送由單片機檢測,從而達到準確測量電機的速度的要求。In this system, the sampling resistance of armature power supply circuit is connected in series to measure the speed of small DC brush motor. The system is mainly composed of second-order low-pass filter circuit, small signal amplifier circuit, single-chip measurement and display circuit, switching regulated power supply circuit and so on. At the same time, the self-made motor speed measuring device uses high frequency magnetic ring as the carrier, coil winding magnetic ring, and electromagnetic induction principle to detect the leakage of magnetic field during the operation of the motor, which converts the changed magnetic field signal into the induced current on the magnetic ring. The weak electric signal is transformed into pulse signal by signal processing unit circuit, which is sent to single chip computer for detection, so as to meet the requirement of accurate measurement of motor speed.
標簽： 直流電動機
上傳時間： 2022-03-26
上傳用戶：
數字示波器功能強大,使用方便,但是價格相對昂貴。本文以Ti的MSP430F5529為主控器,以Altera公司的EP2C5T144C8 FPGA器件為邏輯控制部件設計數字示波器。模擬信號經程控放大、整形電路后形成方波信號送至FPGA測頻,根據頻率值選擇采用片上及片外高速AD分段采樣。FPGA控制片外AD采樣并將數據輸入到FIFO模塊中緩存,由單片機進行頻譜分析。測試表明:簡易示波器可以實現自動選檔、多采樣率采樣、高精度測頻及頻譜分析等功能。Digital oscilloscope is powerful and easy to use, but also expensive. The research group designed a low-cost digital oscilloscope, the chip of MSP430F5529 of TI is chosen as the main controller and the device of EP2C5T144C8 of Altera company is used as the logic control unit. Analog signal enter the programmable amplifier circuit, shaping circuit and other pre-processing circuit. The shaped rectangular wave signal is sent to FPGA for measure the frequency. According to the frequency value to select AD on-chip or off-chip high-speed AD for sampling. FPGA controls the off-chip AD sampling and buffers AD data by FIFO module. The single chip microcomputer receives the data, and do FFT for spectrum analysis. The test shows that the simple oscilloscope can realize automatic gain selection, sampling at different sampling rates, high precision frequency measurement and spectrum analysis.
上傳時間： 2022-03-27
上傳用戶：
電學中的測量技術涉及范圍非常廣,電流測量在電學計量中占有非常重要的位置。如何精確地進行電流測量是精密測量的一大難題。傳統的電流檢測電路多采用運算放大芯片與片外電流檢測電路相結合的方式,電路集成度很低,需要較多的接口和資源才能完成對電路的檢測。本文把所有電路部分都集成在一塊芯片上,包括檢測電阻,運算放大器電路及模擬轉數字轉換電路,從而在電路內部可以進行電流檢測,使電路更好的集成化。前置電路使用二級共源共柵結構的運算放大器,減小溝道長度調制效應造成的電流誤差。10位SAR ADC中采用電容驅動能力強的傳輸門保證了模數轉化器的有效精度。比較器模塊采用再生鎖存器與遲滯比較器作為基礎單元組合解決精密測量的問題。本設計可以作為嵌入芯片內的一小部分而檢測芯片中的微小電流1mA~100mA,工作電壓在1.8v左右,電流檢測精度預期達到10uA的需求。The measurement technology in electricity involves a wide range,and current measurement plays a very important position in electrical measurement.How to accurately measure current is a big problem in precision measurement. The traditional current detecting circuit adopts the combination of the operational amplifier chip and theoff-chip current detecting circuit, The circuit integration is very low, and more interfaces and resources are needed tocomplete the circuit detection.This topic integrates all the circuit parts into one chip, including detection resistance, operational amplifier circuit andanalog to digital conversion circuit. Highly integrated circuit makes the external resources on the chip more intensive,so that current detection can be carried out inside the circuit, so that the circuit can be better integrated. Thefront-end circuit of this project uses two-stage cascade operational amplifier and cascade tube to reduce the currenterror caused by channel length modulation effect. In 10-bit SAR ADC, the transmission gate with strong capacitivedriving ability ensures the effective accuracy of the analog-to-digital converter. Comparator module uses regenerativelatch and hysteresis comparator as basic unit to solve the difficult problem of precision measurement. This topic can beused as a small part of the embedded chip to detect the micro-current in the chip 1 mA~100 mA, the working voltageis about 1.8v, and the current detection accuracy is expected to reach the requirement of 10 uA.
上傳時間： 2022-04-03
上傳用戶：
本文首次設計并驗證了基于macom三合一芯片設計的光模塊電路,該電路旨在提供一種滿足SFF-8472中規定的數字診斷功能的低成本SFP+模塊。電路采用激光器驅動、限幅放大器、控制器以及時鐘恢復單元集成的單芯片,在保證高精度數字診斷功能基礎上,實現了低成本高可靠的特點。該電路在光接收接口組件與激光器驅動和限幅放大器單元的限幅放大器部分之間接入濾波器來提高模塊的靈敏度及信號質量。在控制器單元的數字電位器的引腳上采用外加電阻的方式避免出現上電不發光的故障問題。該研究結果為下一代SFP-DD光模塊設計與開發工作,奠定了一定的理論與實踐基礎。This paper designs and validates the optical module circuit based on the MACOM Trinity chip for the first time.This circuit aims to provide a low-cost SFP module which meets the digital diagnosis function specified in SFF-8472.The circuit uses a single chip integrated with laser driver,limiting amplifier,controller and clock recovery unit.On the basis of ensuring high precision digital diagnosis function,it achieves the characteristics of low cost and high reliability.The circuit connects a filter between the optical receiving interface module and the limiting amplifier part of the laser driver and limiting amplifier unit to improve the sensitivity and signal quality of the module.The pin of the digital potentiometer in the controller unit is equipped with an external resistance to avoid the problem of power failure.The research results lay a theoretical and practical foundation for optical module design in high-speed data center.
上傳時間： 2022-04-03
上傳用戶：
近年來，隨著個人數據通信的發展，功能強大的便攜式數據終端和多媒體終端得到了廣泛的應用。為了實現用戶在任何時間、任何地點均能實現數據通信的目標，要求傳統的計算機網絡由有線向無線、由固定向移動、由單一業務向多媒體發展，這一要求促進了無線局域網技術的發展。在互聯網高速發展的今天，可以認為無線局域網將成為未來的發展趨勢.本課題采用TSMC 0.18um CMOS工藝實現用于IEEE 802.1la協議的5GHz無線局域網接收機射頻前端集成電路一包括低噪聲放大器（Low-Noise amplifier，LNA）和下變頻器電路（Downconverter），低噪聲放大器是射頻接收機前端的主要部分，其作用是在盡可能少引入噪聲的條件下對天線接收到的微弱信號進行放大。下變須器是接收機的重要組成部分，它將低噪聲放大器的輸出射頻信號與本振信號進行混頻，產生中頻信號。論文對射頻前端集成電路的原理進行了分析，比較了不同電路結構的性能，給出了射頻前端集成電路的電路設計、版圖設計、仿真結果和測試方案，仿真結果表明，此次設計的射頻前端集成電路具有低噪聲、低功耗的特點，其它性能也完全滿足設計指標要求
上傳時間： 2022-06-20
上傳用戶：
