Event counter for MSP430 - multi channel and real fast using latched interrupts.
標簽： interrupts counter channel latched
上傳時間： 2014-01-22
上傳用戶：四只眼
vhdl編寫，8b—10b 編解碼器設計 Encoder: 8b/10b Encoder (file: 8b10b_enc.vhd) Synchronous clocked inputs (latched on each clock rising edge) 8-bit parallel unencoded data input KI input selects data or control encoding Asynchronous active high reset initializes all logic Encoded data output 10-bit parallel encoded output valid 1 clock later Decoder: 8b/10b Decoder (file: 8b10b_dec.vhd) Synchronous clocked inputs (latched on each clock rising edge) 10-bit parallel encoded data input Asynchronous active high reset initializes all logic Decoded data, disparity and KO outputs 8-bit parallel unencoded output valid 1 clock later
上傳時間： 2016-05-05
上傳用戶：gundamwzc
Top module name : SHIFTER (File name : SHIFTER.v) 2. Input pins: SHIFT [3:0], IN [15:0], SIGN, RIGHT. 3. Output pins: OUT [15:0]. 4. Input signals generated from test pattern are latched in one cycle and are synchronized at clock rising edge. 5. The SHIFT signal describes the shift number. The shift range is 0 to 15. 6. When the signal RIGHT is high, it shifts input data to right. On the other hand, it shifts input data to left. 7. When the signal SIGN is high, the input data is a signed number and it shifts with sign extension. However, the input data is an unsigned number if the signal SIGN is low. 8. You can only use following gates in Table I and need to include the delay information (Tplh, Tphl) in your design.
標簽： SHIFTER name module Input
上傳時間： 2013-12-13
上傳用戶：himbly
Top module name : SHIFTER (File name : SHIFTER.v) 2. Input pins: SHIFT [3:0], IN [15:0], SIGN, RIGHT. 3. Output pins: OUT [15:0]. 4. Input signals generated from test pattern are latched in one cycle and are synchronized at clock rising edge. 5. The SHIFT signal describes the shift number. The shift range is 0 to 15. 6. When the signal RIGHT is high, it shifts input data to right. On the other hand, it shifts input data to left. 7. When the signal SIGN is high, the input data is a signed number and it shifts with sign extension. However, the input data is an unsigned number if the signal SIGN is low. 8. You can only use following gates in Table I and need to include the delay information (Tplh, Tphl) in your design.
標簽： SHIFTER name module Input
上傳時間： 2014-01-20
上傳用戶：三人用菜
The SL74HC573 is identical in pinout to the LS/ALS573. The device inputs are compatible with standard CMOS outputs with pullup resistors, they are compatible with LS/ALSTTL outputs. These latches appear transparent to data (i.e., the outputs change asynchronously) when Latch Enable is high. When Latch Enable goes low, data meeting the setup and hold time becomes latched.
標簽： compatible The 573 identical
上傳時間： 2016-12-29
上傳用戶：變形金剛
蟲蟲下載站版權所有 京ICP備2021023401號-1
