Introduction to Xilinx Packaging Electronic packages are interconnectable housings for semiconductor devices. The major functions of the electronic packages are to provide electrical interconnections between the IC and the board and to efficiently remove heat generated by the device. Feature sizes are constantly shrinking, resulting in increased number of transistors being packed into the device. Today's submicron technology is also enabling large-scale functional integration and system-on-a-chip solutions. In order to keep pace with these new advancements in silicon technologies, semiconductor packages have also evolved to provide improved device functionality and performance. Feature size at the device level is driving package feature sizes down to the design rules of the early transistors. To meet these demands, electronic packages must be flexible to address high pin counts, reduced pitch and form factor requirements. At the same time,packages must be reliable and cost effective.
上傳時間： 2013-11-21
上傳用戶：不懂夜的黑
針對嵌入式機器視覺系統向獨立化、智能化發展的要求，介紹了一種嵌入式視覺系統--智能相機。基于對智能相機體系結構、組成模塊和圖像采集、傳輸和處理技術的分析，對國內外的幾款智能相機進行比較。綜合技術發展現狀，提出基于FPGA+DSP模式的硬件平臺，并提出智能相機的發展方向。分析結果表明，該系統設計可以實現脫離PC運行，完成圖像獲取與分析，并作出相應輸出。 Abstract: This paper introduced an embedded vision system-intelligent camera ，which was for embedded machine vision systems to an independent and intelligent development requirements. Intelligent camera architecture， component modules and image acquisition， transmission and processing technology were analyzed. After comparing integrated technology development of several intelligent cameras at home and abroad， the paper proposed the hardware platform based on FPGA+DSP models and made clear direction of development of intelligent cameras. On the analysis of the design， the results indicate that the system can run from the PC independently to complete the image acquisition and analysis and give a corresponding output.
上傳時間： 2013-11-14
上傳用戶：無聊來刷下
數字與模擬電路設計技巧IC與LSI的功能大幅提升使得高壓電路與電力電路除外，幾乎所有的電路都是由半導體組件所構成，雖然半導體組件高速、高頻化時會有EMI的困擾，不過為了充分發揮半導體組件應有的性能，電路板設計與封裝技術仍具有決定性的影響。 模擬與數字技術的融合由于IC與LSI半導體本身的高速化，同時為了使機器達到正常動作的目的，因此技術上的跨越競爭越來越激烈。雖然構成系統的電路未必有clock設計，但是毫無疑問的是系統的可靠度是建立在電子組件的選用、封裝技術、電路設計與成本，以及如何防止噪訊的產生與噪訊外漏等綜合考慮。機器小型化、高速化、多功能化使得低頻/高頻、大功率信號/小功率信號、高輸出阻抗/低輸出阻抗、大電流/小電流、模擬/數字電路，經常出現在同一個高封裝密度電路板，設計者身處如此的環境必需面對前所未有的設計思維挑戰，例如高穩定性電路與吵雜(noisy)性電路為鄰時，如果未將噪訊入侵高穩定性電路的對策視為設計重點，事后反復的設計變更往往成為無解的夢魘。模擬電路與高速數字電路混合設計也是如此，假設微小模擬信號增幅后再將full scale 5V的模擬信號，利用10bit A/D轉換器轉換成數字信號，由于分割幅寬祇有4.9mV，因此要正確讀取該電壓level并非易事，結果造成10bit以上的A/D轉換器面臨無法順利運作的窘境。另一典型實例是使用示波器量測某數字電路基板兩點相隔10cm的ground電位，理論上ground電位應該是零，然而實際上卻可觀測到4.9mV數倍甚至數十倍的脈沖噪訊(pulse noise)，如果該電位差是由模擬與數字混合電路的grand所造成的話，要測得4.9 mV的信號根本是不可能的事情，也就是說為了使模擬與數字混合電路順利動作，必需在封裝與電路設計有相對的對策，尤其是數字電路switching時，ground vance noise不會入侵analogue ground的防護對策，同時還需充分檢討各電路產生的電流回路(route)與電流大小，依此結果排除各種可能的干擾因素。以上介紹的實例都是設計模擬與數字混合電路時經常遇到的瓶頸，如果是設計12bit以上A/D轉換器時，它的困難度會更加復雜。
上傳時間： 2014-02-12
上傳用戶：wenyuoo
基于通用集成運算放大器，利用MASON公式設計了一個多功能二階通用濾波器，能同時或分別實現低通、高通和帶通濾波，也能設計成一個正交振蕩器。電路的極點頻率和品質因數能夠獨立、精確地調節。電路使用4個集成運放、2個電容和11個電阻，所有集成運放的反相端虛地。利用計算機仿真電路的通用濾波功能、極點頻率和品質因數的獨立控制和正交正弦振蕩，從而證明該濾波器正確有效。 Abstract: A new multifunctional second-order filter based on OPs was presented by MASON formula. Functions， such as high-pass， band-pass， low-pass filtering， can be realized respectively and simultaneously， and can become a quadrature oscillator by modifying resistance ratio. Its pole angular frequency and quality factor can be tuned accurately and independently. The circuit presented contains four OPs， two capacitors， and eleven resistances， and inverting input of all OPs is virtual ground. Its general filtering， the independent control of pole frequency and quality factor and quadrature sinusoidal oscillation were simulated by computer， and the result shows that the presented circuit is valid and effective.
上傳時間： 2013-10-09
上傳用戶：13788529953
Contains a complete archiver by Haruhiko Okumura. The archiver uses an LZ engine whose output is compressed with static Huffman. The file is chopped into pieces which all get their own independent set of Huffman tree s. ARJ 2.41, ZIP 2.0 and PKZIP 2.04g use essentially the same method. ZOO and LHA even use excactly the same method.
標簽： archiver Contains complete Haruhiko
上傳時間： 2014-01-17
上傳用戶：himbly
The GRLIB IP Library is an integrated set of reusable IP cores, designed for system-on-chip (SOC) development. The IP cores are centered around the common on-chip bus, and use a coherent method for simulation and synthesis. The library is vendor independent, with support for different CAD tools and target technologies. A unique plug&play method is used to configure and connect the IP cores without the need to modify any global resources.
標簽： system-on-chip integrated designed reusable
上傳時間： 2013-12-20
上傳用戶：小眼睛LSL
ICA can be used in brain activation studies to reduce the number of dimension and filter out independent and interesting activations. This demonstration shows two studies. One provided by Hvidovre Universitets Hospital, Denmark, that consists of fMRI scannings of humans. Another provided by the EU sponsored MAPAWAMO project from fMRI scannings of monkeys. In the demo comparison between icaMS, icaML, icaMF, icaMF (positive sources) and PCA can be made. More detailes can found in [2].
標簽： activation dimension studies indepen
上傳時間： 2015-04-19
上傳用戶：zukfu
The Molgedey and Schuster decorrelation algorithm, having square mixing matrix and no noise . Truncation is used for the time shifted matrix, and it is forced to be symmetric . The delay Tau is estimated . The number of independent components are calculated using Bayes Information Criterion (BIC), with PCA for dimension reduction.
標簽： decorrelation and algorithm Molgedey
上傳時間： 2013-12-13
上傳用戶：c12228
Although there has been a lot of AVL tree libraries available now, nearly all of them are meant to work in the random access memory(RAM). Some of them do provide some mechanism for dumping the whole tree into a file and loading it back to the memory in order to make data in that tree persistent. It serves well when there s just small amount of data. When the tree is somewhat bigger, the dumping/loading process could take a lengthy time and makes your mission-critical program less efficient. How about an AVL tree that can directly use the disk for data storage ? If there s something like that, we won t need to read through the whole tree in order to pick up just a little bit imformation(a node), but read only the sectors that are neccssary for locating a certain node and the sectors in which that node lies. This is my initial motivation for writing a storage-media independent AVL Tree. However, as you step forth, you would find that it not only works fine with disks but also fine with memorys, too.
標簽： available libraries Although nearly
上傳時間： 2014-01-22
上傳用戶：zhoujunzhen
很好的linux內核調試軟件 兼轅馬，沒有密碼。 The ia64 and ix86 directories contain versions of kdb prior to v2.0 (kdb version v2.0, not the kernel version). Older versions of kdb had complete patches for each architecture it supported, each patch included all the common kdb code. This format was awkward to maintain and use for multiple platforms. Starting with kdb v2.0 there is a common patch against each kernel which contains all the architecture independent code plus separate architecture dependent patches. Either use an old style (v1.8 or v1.9) kdb patch or use a new style (v2.0) common patch plus the corresponding architecture dependent patch.
上傳時間： 2014-01-21
上傳用戶：wyc199288
