The following Philips LPC2k CAN examples in this directory
were provided by ESAcademy.
LPC2_CANAll_V110:
Receives all CAN messages in a receive queue.
LPC2_CANFull_V110:
Uses Full-CAN-like reception filtering.
LPC2_CANBlinky_V130:
Minimal example of MicroCANopen, uses Full-CAN-like
reception filtering and implements both Rx and Tx
Interrupt Service Routines.
The following Philips LPC2k CAN examples in this directory
were provided by ESAcademy.
LPC2_CANAll_V110:
Receives all CAN messages in a receive queue.
LPC2_CANFull_V110:
Uses Full-CAN-like reception filtering.
LPC2_CANBlinky_V130:
Minimal example of MicroCANopen, uses Full-CAN-like
reception filtering and implements both Rx and Tx
Interrupt Service Routines.
A system simulation environment in Matlab/Simulink of RFID is constructed in this paper.
Special attention is emphasized on the analog/RF circuit.Negative effects are concerned in the system
model,such as phase noise of the local oscillator,TX-RX coupling,reflection of the environment,
AWGN noise,DC offset,I/Q mismatch,etc.Performance of the whole system can be evaluated by
changing the coding method,parameters of building blocks,and operation distance.Finally,some
simulation results are presented in this paper.
smsc911x 網卡驅動
This the users/programmers guide for the LAN911x Linux Driver
The following sections can be found below
* Revision History
* Files
* Features
* Driver Parameters
* Rx Performance Tuning
* Tested Platforms
* Rx Code Path
* Tx Code Path
* Platform Interface Descriptions
基于OFDM的無線寬帶系統仿真It contains mainly two parts, i.e. link-level simulator and system-level simulator.
Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation.
System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate.
NRF905驅動代碼
// The content of this struct is nRF905 s initialize data.
// CH_NO=1 433MHZ Normal Opration,No Retrans RX,TX Address is 4 Bytes
// RX TX Payload Width is 32 Bytes Disable Extern Clock Fosc=16MHZ
// 8 Bits CRC And enable
Description: This program demonstrates a half-duplex 9600-baud UART using
// Timer_A3 using no XTAL and an external resistor for DCO ROSC. DCO used for
// TACLK UART baud generation. The program will wait in LPM4, echoing back
// a received character using 8N1 protocol. On valid RX character, the
// character is echoed back.
// Using a 100k resistor on ROSC, with default DCO setting, set DCOCLK ~ 2MHz.
// ACLK = n/a, MCLK = SMCLK ~2MHz DCOCLK
