WP409利用Xilinx FPGA打造出高端比特精度和周期精度浮點DSP算法實現方案： High-Level Implementation of Bit- and Cycle-Accurate Floating-Point DSP Algorithms with Xilinx FPGAs
上傳時間： 2013-10-21
上傳用戶：huql11633
SRAM-based FPGAs are non-volatile devices. Upon powerup, They are required to be programmed from an external source. This procedure allows anyone to easily monitor the bit-stream, and clone the device. The problem then becomes how can you effectively protect your intellectual property from others in an architecture where the part is externally programmed?
上傳時間： 2013-10-20
上傳用戶：磊子226
各種功能的計數器實例（VHDL源代碼）:ENTITY counters IS PORT ( d : IN INTEGER RANGE 0 TO 255; clk : IN BIT; clear : IN BIT; ld : IN BIT; enable : IN BIT; up_down : IN BIT; qa : OUT INTEGER RANGE 0 TO 255; qb : OUT INTEGER RANGE 0 TO 255; qc : OUT INTEGER RANGE 0 TO 255; qd : OUT INTEGER RANGE 0 TO 255; qe : OUT INTEGER RANGE 0 TO 255; qf : OUT INTEGER RANGE 0 TO 255; qg : OUT INTEGER RANGE 0 TO 255; qh : OUT INTEGER RANGE 0 TO 255; qi : OUT INTEGER RANGE 0 TO 255;
上傳時間： 2013-10-09
上傳用戶：松毓336
特點 顯示范圍0至19999(瞬間量),0至999999999(9位數累積量)可任意規劃 精確度0.03%滿刻度(瞬間量) 頻率輸入范圍 0.01Hz 至 10KHz 瞬間量與累積量時間基數可任意規劃(1 或 60 或 3600 秒) 瞬間量之最高顯示值可任意規劃(0至19999) 累積量之輸入脈波比例刻畫調整可任意規劃(0.00001至9999.99999) 具有二組警報功能 15 BIT 隔離類比輸出 數位RS-485 界面 數位脈波同步輸出功能
上傳時間： 2014-11-07
上傳用戶：xaijhqx
特點 顯示范圍-19999至99999位數 最高輸入頻率 10KHz 計數速度 50,5000脈波/秒可選擇 四種輸入模式可選擇(加算,減算,加減算,90度相位差加減算 90度相位差加減算具有提高解析度4倍功能 輸入脈波具有預設刻度功能 2組警報功能 15 BIT 類比輸出功能 數位RS-485介面
上傳時間： 2013-10-15
上傳用戶：1039312764
特點 精確度0.1%滿刻度 ±1位數 可同事量測與顯示交流電壓/交直流電流 顯示范圍0- ±19999可任意規劃 類比輸出運算功能 (IN1,IN2,IN1+IN2,IN1-IN2,IN1xIN2,IN1/IN2)) 2組獨立警報功能 15 BIT 類比輸出功能 數位RS-485界面
上傳時間： 2013-11-22
上傳用戶：youke111
基于通用集成運算放大器，利用MASON公式設計了一個多功能二階通用濾波器，能同時或分別實現低通、高通和帶通濾波，也能設計成一個正交振蕩器。電路的極點頻率和品質因數能夠獨立、精確地調節。電路使用4個集成運放、2個電容和11個電阻，所有集成運放的反相端虛地。利用計算機仿真電路的通用濾波功能、極點頻率和品質因數的獨立控制和正交正弦振蕩，從而證明該濾波器正確有效。 Abstract: A new multifunctional second-order filter based on OPs was presented by MASON formula. Functions， such as high-pass， band-pass， low-pass filtering， can be realized respectively and simultaneously， and can become a quadrature oscillator by modifying resistance ratio. Its pole angular frequency and quality factor can be tuned accurately and independently. The circuit presented contains four OPs， two capacitors， and eleven resistances， and inverting input of all OPs is virtual ground. Its general filtering， the independent control of pole frequency and quality factor and quadrature sinusoidal oscillation were simulated by computer， and the result shows that the presented circuit is valid and effective.
上傳時間： 2013-10-09
上傳用戶：13788529953
SL811開發資料_包含源程序_電路圖_芯片資料:SL811HS Embedded USB Host/Slave Controller.The SL811HS is an Embedded USB Host/Slave Controller capable of communicate with either full-speed or low-speed USB peripherals. The SL811HS can interface to devices such as microprocessors, microcontrollers, DSPs, or directly to a variety of buses such as ISA, PCMCIA, and others. The SL811HS USB Host Controller conforms to USB Specification 1.1.The SL811HS USB Host/Slave Controller incorporates USB Serial Interface functionality along with internal full-/low-speed transceivers.The SL811HS supports and operates in USB full-speed mode at 12 Mbps, or at low-speed 1.5-Mbps mode.The SL811HS data port and microprocessor interface provide an 8-bit data path I/O or DMA bidirectional, with interrupt support to allow easy interface to standard microprocessors or microcontrollers such as Motorola or Intel CPUs and many others. Internally,the SL811HS contains a 256-byte RAM data buffer which is used for control registers and data buffer.The available package types offered are a 28-pin PLCC (SL811HS) and a 48-pin TQFP package (SL811HST-AC). Both packages operate at 3.3 VDC. The I/O interface logic is 5V-tolerant.
上傳時間： 2013-12-22
上傳用戶：a82531317
12864液晶時鐘顯示程序 LCD 地址變量 ;**************變量的定義***************** RS BIT P2.0 ;LCD數據/命令選擇端(H/L) RW BIT P2.1 ;LCD讀/寫選擇端(H/L) EP BIT P2.2 ;LCD使能控制 PSB EQU P2.3 RST EQU P2.5 PRE BIT P1.4 ;調整鍵(K1) ADJ BIT P1.5 ;調整鍵(K2) COMDAT EQU P0 LED EQU P0.3 YEAR DATA 18H ;年,月,日變量 MONTH DATA 19H DATE DATA 1AH WEEK DATA 1BH HOUR DATA 1CH ;時,分,秒,百分之一秒變量 MIN DATA 1DH SEC DATA 1EH SEC100 DATA 1FH STATE DATA 23H LEAP BIT STATE.1 ;是否閏年標志1--閏年，0--平年 KEY_S DATA 24H ;當前掃描鍵值 KEY_V DATA 25H ;上次掃描鍵值 DIS_BUF_U0 DATA 26H ;LCD第一排顯示緩沖區 DIS_BUF_U1 DATA 27H DIS_BUF_U2 DATA 28H DIS_BUF_U3 DATA 29H DIS_BUF_U4 DATA 2AH DIS_BUF_U5 DATA 2BH DIS_BUF_U6 DATA 2CH DIS_BUF_U7 DATA 2DH DIS_BUF_U8 DATA 2EH DIS_BUF_U9 DATA 2FH DIS_BUF_U10 DATA 30H DIS_BUF_U11 DATA 31H DIS_BUF_U12 DATA 32H DIS_BUF_U13 DATA 33H DIS_BUF_U14 DATA 34H DIS_BUF_U15 DATA 35H DIS_BUF_L0 DATA 36H ;LCD第三排顯示緩沖區 DIS_BUF_L1 DATA 37H DIS_BUF_L2 DATA 38H DIS_BUF_L3 DATA 39H DIS_BUF_L4 DATA 3AH DIS_BUF_L5 DATA 3BH DIS_BUF_L6 DATA 3CH DIS_BUF_L7 DATA 3DH DIS_BUF_L8 DATA 3EH DIS_BUF_L9 DATA 3FH DIS_BUF_L10 DATA 40H DIS_BUF_L11 DATA 41H DIS_BUF_L12 DATA 42H DIS_BUF_L13 DATA 43H DIS_BUF_L14 DATA 44H DIS_BUF_L15 DATA 45H FLAG DATA 46H ;1-年，2-月，3-日，4-時，5-分，6-秒，7-退出調整。 DIS_H DATA 47H DIS_M DATA 48H DIS_S DATA 49H
上傳時間： 2013-12-25
上傳用戶：wvbxj
溫濕度傳感器 sht11 仿真程序 sbit out =P3^0; //加熱口 //sbit input =P1^1;//檢測口 //sbit speek =P2^0;//報警 sbit clo =P3^7;//時鐘 sbit ST =P3^5;//開始 sbit EOC =P3^6;//成功信號 sbit gwei =P3^4;//個位 sbit swei =P3^3;//十位 sbit bwei =P3^2;//百位 sbit qwei =P3^1;//千位 sbit speak =P0^0;//報警音 sbit bjled =P0^1;//報警燈 sbit zcled =P0^2;//正常LED int count; uchar xianzhi;//取轉換結果 uchar seth;//高時間 uchar setl;//低時間 uchar seth_mi;//高時間 uchar setl_mi;//低時間 bit hlbz;//高低標志 bit clbz; bit spbz; ///定時中斷程序/// void t0 (void) interrupt 1 using 0 { TH0=(65536-200)/256;//5ms*200=1000ms=1s TL0=(65536-200)%256; clo=!clo;//產生時鐘 if(count>5000) { if(hlbz) { if(seth_mi==0){seth_mi=seth;hlbz=0;out=0;} else seth_mi--; } if(!hlbz) { if(setl_mi==0){setl_mi=setl;hlbz=1;out=1;} else setl_mi--; } count=0; } else count++; } ///////////// ///////延時/////// delay(int i) { while(--i); } ///////顯示處理/////// xianshi() { int abcd=0; int i; for (i=0;i<5;i++) { abcd=xianzhi; gwei=1; swei=1; bwei=1; qwei=1; P1=dispcode[abcd/1000]; qwei=0; delay(70); qwei=1; abcd=abcd%1000; P1=dispcode[abcd/100]; bwei=0; delay(70); bwei=1; abcd=abcd%100; P1=dispcode[abcd/10]; swei=0; delay(70); swei=1; abcd=abcd%10; P1=dispcode[abcd]; gwei=0; delay(70); gwei=1; } } doing() { if(xianzhi>100) {bjled=0;speak=1;zcled=1;} else {bjled=1;speak=0;zcled=0;} } void main(void) { seth=60;//h60秒 setl=90;//l90秒 seth_mi=60;//h60秒 setl_mi=90;//l90秒 TMOD=0X01;//定時0 16位工作模式 TH0=(65536-200)/256; TL0=(65536-200)%256; TR0=1; //開始計時 ET0=1; //開定時0中斷 EA=1; //開全中斷 while(1) { ST=0; _nop_(); ST=1; _nop_(); ST=0; // EOC=0; xianshi(); while(!EOC) { xianshi(); } xianzhi=P2; xianshi(); doing(); } }
上傳時間： 2013-10-16
上傳用戶：黃蛋的蛋黃
